The mounting screws for these rim brake calipers are missing one of its washers. I have personally found it quite difficult to source a replacement, so unless you happen to have a spare in your parts bin, you will have to fabricate one. The washer has a larger diameter than the head of the mounting screws, so while it is possible to install these brakes without the washer, it is possible that doing so may stress the brake caliper beyond Shimano’s expectations. If you ride these brakes without this washer, understand that you do so AT YOUR OWN RISK. Otherwise, these rim brake calipers are in good condition with no damage compromising their rideworthiness and no scuffs or scrapes inconsistent with used bicycle parts. In addition to the washer mentioned above, these rim brake calipers are missing their brake shoes, brake pads, and cable noodles; you will have to source those separately. As these brakes are ridden, the parallelogram linkage develops play. This is normal, and Shimano specifies a service procedure to remove this play using a special service kit containing shims and adhesive caps; however, this service kit has been out of production for two decades and is extremely difficult to obtain. Compatible shims are easy to find, but to perform this service, I have had to substitute the adhesive seals for tubes of toothpaste in place of the adhesive caps. Thank you for your consideration. If you have any questions or concerns, please do not hesitate to ask.